POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This product is intended to be supplied by a UL listed or CSA Certified Power unit with “Class
2” or LPS power source.
CSA CERTIFIED
218441
CE COMPLIANCE
CE marking states the compliance of the product with essential requirements listed in the
applicable European directive. Since the directives and applicable standards are subject to
continuous updates, and since Datalogic promptly adopts these updates, therefore the EU
declaration of conformity is a living document. The EU declaration of conformity is available
for competent authorities and customers through Datalogic commercial reference contacts.
Since April 20th, 2016 the main European directives applicable to Datalogic products require
inclusion of an adequate analysis and assessment of the risk(s). This evaluation was carried
out in relation to the applicable points of the standards listed in the Declaration of Conformity.
Datalogic Automation products are mainly designed for integration purposes into more
complex systems. For this reason it is under the responsibility of the system integrator to do
a new risk assessment regarding the final installation.
WARNING: Disconnect the power supply when installing the device or during maintenance
to avoid unintentional exposure to laser light.
WARNING: There are no user serviceable parts inside the barcode scanner. Service
should only be performed by Datalogic trained and certified technicians.
Any violation of the optical parts in particular could result in exposure to Class 3B laser
light.
WARNING: This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
To Next Page
Loading...
Need help?
General
