CONVENTIONS
COMPLIANCE
ELECTRICAL SAFETY
This product conforms to the applicable requirements contained in the European Standard
for electrical safety EN 60950 at the date of manufacture.
LASER SAFETY
The following information is provided to comply with the rules imposed by international
authorities and refers to the correct use of the DS8110 barcode scanners.
Standard Regulations
These barcode scanners use low-power laser diodes. Avoid staring at the beam as one
would with any very strong light source, such as the sun.
Take care when installing the laser device to avoid inadvertent laser beam contact with the
eye of an observer, including through reflective surfaces.
This product conforms to the applicable requirements of IEC 60825-1 and complies with 21
CFR 1040.10 except for deviations pursuant to Laser Notice N° 50, date June 24, 2007. The
scanner is classified as a Class 2 laser product according to IEC 60825-1 regulations.
There is a safety device which allows the laser to be switched on only if the motor is rotating
above the threshold for its correct scanning speed.
WARNING: Use of controls or adjustments or performance
of procedures other than those specified herein may result
in exposure to hazardous visible laser light.
BUREAU OF INDIAN STANDARD (BIS)
WARNINGS OR CAUTIONS: This symbol identifies a hazard or procedure that, if
incorrectly performed, could cause personal injury or result in equipment damage. It is also
used to bring the user’s attention to details that are considered IMPORTANT.
HIGH VOLTAGE CAUTION: This symbol alerts the user they are about to perform an
action involving, either a dangerous level of voltage, or to warn against an action that could
result in damage to devices or electrical shock.
LASER CAUTION: This symbol alerts the user they are about to perform an action
involving possible exposure to laser light radiation.
ESD CAUTION: This symbol identifies a procedure that requires you take measures to
prevent Electrostatic Discharge (ESD) e.g., use an ESD wrist strap. Circuit boards are
most at risk. Please follow ESD procedures.
NOTES: This symbol draws attention to details or procedures that may be useful in
improving, maintaining, or enhancing the performance of the hardware or software being
discussed.
To Next Page
Loading...
Need help?
General
