4.5.5 Modify Settings | Global Settings | Ethernet
Use the Ethernet menu tree selections during initial setup to configure the Ethernet settings
for your barcode scanning system.
Ethernet is the most popular physical layer LAN technology in use today. It is the IEEE 802.3
series standard, based on the CSMA/CD access method that provides two or more stations
to share a common cabling system. This access method, Carrier Sense Multiple Access with
Collision Detection, is the basis for Ethernet systems providing a wide range of speed.
The design goals for Ethernet are to create a simply defined topology that makes efficient
use of shared resources that are easy to reconfigure and maintain and provides compatibility
across many manufacturer and systems.
Ethernet supports many different network protocols; Datalogic scanners support IP plus TCP
or UDP over Ethernet and 802.3 frame format as Ethernet protocol low level.
If necessary, you can later make modifications to the global system settings using the same
menu selections, including:
To Next Page
Loading...
Need help?
General
