2 MECHANICAL INSTALLATION
2.1 PREPARING FOR MECHANICAL INSTALLATION
Before mounting any components, please do the following:
Read all instructions before beginning your installation.
Define and confirm the accuracy of your application’s requirements and structure
position, especially the height of the conveyor from the floor.
Review all installation-specific drawings provided with your equipment.
Review and plan the mechanical installation of all devices used in your application. Be
sure to allow adequate clearance for maintenance.
Review and plan the power requirements for your application.
Check the contents of the shipping cartons against the packing list.
Record all product serial numbers.
WARNING: Electrical Installation by Qualified Service Technicians Only!
Procedures may involve exposure to high-voltage. A trained and authorized
technician must perform these procedures. Do not attempt to perform any
electrical installation procedures unless you are a trained technician.
IMPORTANT: DS8110 barcode scanners contain electronics that may be
affected by electrostatic discharge (ESD). To prevent personal injury or
damage to the unit, please follow the safety precautions and warnings found in
the References section at the beginning of this manual. Failure to follow these
precautions may void your warranty.
IMPORTANT: Application-specific drawings and documents provided by
Datalogic supersede any contradictory content in this manual.
NOTE: : Refer to the Chapter 3 Electrical Installation and Reference
Documentation for details on connecting your barcode scanners to other
devices in the system.
WARNING: When installing several scanners, take care to position them so
that no laser beam enters the reading window of other scanners. This condition
could occur more frequently for side mounted applications. If these precautions
are not followed, read rate could be negatively affected. To resolve this
problem, it is sufficient to slightly change the inclination and position of one of
the two scanners involved if possible.
To Next Page
Loading...
Need help?
General
