3 ELECTRICAL INSTALLATION
3.1 PREPARING FOR ELECTRICAL INSTALLATION
Before mounting any components, please do the following:
Read all instructions before beginning your installation.
Observe all electrical safety requirements discussed in the Introduction to this manual.
Define and confirm the accuracy of your application’s requirements.
Review all installation-specific drawings.
Review and plan the power requirements for your application.
Review and plan the communications requirements for your application.
IMPORTANT: The content of this manual may be superseded by any
customer-specific documentation provided by Datalogic. Before proceeding
with any installation procedures, be sure to review ALL documentation,
especially content that contains details specific to your installation.
NOTE: Everything should be MECHANICALLY INSTALLED before
performing any ELECTRICAL INSTALLATION. See Chapter 2 for mechanical
installation details.
Most DS8110 applications are shipped with the CBX connection box and all
the necessary cabling required to electrically install the system. If your system
requires custom-length cables or other special wiring, documentation specific
to these requirements has been provided in your shipment. This special
documentation supersedes any contradictory content in this manual.
NOTE: To reduce the possibility of damage to the unit, check all cabling
between the scanner and other devices for accuracy.
WARNING: Electrical Installation by Qualified Service Technicians Only!
Procedures may involve exposure to high-voltage. A trained and authorized
technician must perform these procedures. Do not attempt to perform any
electrical installation procedures unless you are a trained technician.
IMPORTANT: The DS8110 barcode scanners contain electronics that may be
affected by electrostatic discharge (ESD). To prevent personal injury or
damage to the unit, please follow the safety precautions and warnings found in
the References section at the beginning of this manual. Failure to follow these
precautions may void your warranty.
To Next Page
Loading...
Need help?
General
