7. When everything is powered up, connect a laptop to the CFG port on the front of the
SC5000. In a open (non-ring) system, the laptop can be connected to ETH2 of the
scanner.
8. Open a browser and enter the default IP (192.168.3.100, see section 4.1.2.). e-Genius
opens.
NOTE: Detailed information on connecting a laptop to the system and
using e-Genius is available in Chapter 4.
9. Log on to e-Genius (see section 4.1.2.).
10. From the menu tree, select Modify Settings | System Info.
11. If Master is selected, the system is poled, and the other scanners are added to the
Device information list. The SC5000 Controller always serves as the Master when used.
To Next Page
Loading...
