Datalogic DS8110

DS8110 REFERENCE MANUAL
204
5
6. Click Start Test. The scanner should successfully read the barcode. If it doesn’t, read
successfully or registers a low read rate, check the system specifications for mounting
distance and barcode specifications. Then make adjustments as necessary and repeat
the test. If the scanner continues to have problems reading the barcode, contact
Datalogic (www.datalogic.com).
NOTE: A read test tool has now been added to the bottom section of the PackTrack
Calibration Wizard, which can supply the read rate and XYZ coordinates.
7. Repeat the test for both legs (each laser line of the X-pattern) of a DX8210 scanner.
8. Click Stop Test.
0.