SOFTWARE CONFIGURATION
164
MATRIX 220
RESTORE DEFAULTS
The device parameters are divided into two main classes, Configuration and Environ-
ment which are affected differently by the Restore Defaults commands.
• The Configuration parameters are the ones set in the various steps of the configu-
ration process and are specific to each application. When multiple configurations
(job
s) are saved on a single device, these parameters can be different from one
configuration to the next.
• Environment parameters regard the device
Identity
and Position in a Network
(Ethernet, ID-NET, etc.) and are not influenced by the Default (or any other) Con-
figuration present in memory.
Restore Default Startup Configuration
The Default configuration is always present on the reader and in fact it is not modifiable
and cannot be deleted. It can always be restored by simply selecting it from the Open
from Device configuration list.
The same action can be performed from the Device menu >Backup/Restore > Restore
Defaults > Restore Default Startup Configuration. The Default Configuration will be set
to run at startup and the reader will be reset.
Any previously saved configurations on the device will remain in memory, but the
Default configuration is set as the startup configuration.
To Next Page
Loading...
Need help?
General
