PRODUCT REFERENCE GUIDE
ix
COMPLIANCE
GENERAL
For installation, use and maintenance it is not necessary to open the reader.
Only connect Ethernet and dataport connectio
ns to a network which has routing only
within the plant or building and no routing outside the plant or building
POWER SUPPLY
ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT
This product is intended to be installed by Qualified Pe
rsonnel only.
This product is intended to be connected to a UL Listed Computer (LPS or “Class 2”)
which supplies
power directly to the reader, or a UL Listed Direct Plug-in Power Unit
(rated 10 to 30 V, minimum 1 A) marked LPS or “Class 2”, or Power over Ethernet source
Device supplied by UL Listed Direct Plug-in Power Unit marked LPS or “Class 2”.
EMC COMPLIANCE
In order to meet the EMC requirements:
• connect reader chassis to the plant earth ground by means of a flat copper braid
short
er than 100 mm;
• connect pin "Earth" of the CBX connection box to a good Earth Ground;
• for direct connections, connect your cable shield to the locking ring nut of the con-
nector.
CE COMPLIANCE
CE marking states the compliance of the product with essential requirements listed in
the applicable European directive. Since the directives and applicable standards are
subject to continuous updates, and since Datalogic promptly adopts these updates,
therefore the EU declaration of conformity is a living document. The EU declaration of
conformity is available for competent authorities and customers through Datalogic
commercial reference contacts. Since April 20th, 2016 the main European directives
applicable to Datalogic products require inclusion of an adequate analysis and assess-
ment of the risk(s). This evaluation was carried out in re
lation to the applicable points of
the standards listed in the Declaration of Conformity. Datalogic products are mainly
designed for integration purposes into more complex systems. For this reason it is under
To Next Page
Loading...
Need help?
General
