3. Remove the air shroud.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the removal procedure.
Figure 81. Removing the intrusion switch
Steps
1. Disconnect the intrusion-switch cable from the connector on the system board.
2. Unroute the intrusion switch cable and speaker cable off the cable clip.
3. Unroute the speaker-dongle cable from the routing guide on the intrusion switch.
4. Remove the single (#6-32) screw that secures the intrusion switch to the chassis.
5. Remove the intrusion switch along with the cable away from the computer.
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the installation
procedure.
Removing and installing Customer Replaceable Units (CRUs)
109
To Next Page
Loading...
