Network Interface Card (NIC)
Installing the 10G network adapter
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 10 G network adapter and provide a visual representation of the installation
procedure.
NOTE: Precision 7875 Tower supports only one 10 G network adapter in slots 6, 5, 4, or 1.
Figure 71. Installing the 10G network adapter
Steps
1. Push down the PCIe latch to open the PCIe door.
2. Slide and lift the PCIe filler from the PCIe slot.
98
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
