9. Align the screw holes on the solid state drive heat sink with screw holes on the UltraSpeed Duo card.
10. Tighten the two captive screws that secure the solid state drive heat sink in place.
11. Close the fan shroud and press until it clicks in place.
NOTE: The UltraSpeed Duo card can support two solid state drives. Repeat step 1 to step 10 to install the solid state
drive into the second slot.
Next steps
1. Install the UltraSpeed Duo card.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Removing the UltraSpeed Duo card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the UltraSpeed Duo card and provide a visual representation of the removal
procedure.
NOTE: Precision 7875 Tower supports only one UltraSpeed Duo card in slot 6, 5, or 4.
Removing and installing Customer Replaceable Units (CRUs) 83
To Next Page
Loading...
