HEALTH & SAFETY
Lethal voltages
personnel may carry out maintenance work.
Observe all statutory electrical safety codes and practi
is necessary to run the printer, disconnect the print
mains electrical supply service before removing the cover or
Lethal voltages are present within this equipment w
connected to the mains supply. Only
hen it is
trained and authorised
ces. Unless it
er from the
attempting any service or repair activity, otherwise death or
Compre
personal injury may result.
ssed air supply
To avoid the risk of injury to personnel or damage to the
equipment, do not exceed the flow and pressure specification.
Battery replacement
Replaceable batteries should only be replaced using
the same type and ra
batteries of
ting. Failure to do so may result in an
explosion hazard.
atteries should be disposed of according to the battery
Fuses fire hazard
Used b
manufactures instructions.
To ensure continued protection against the risk of fire, replace
fuses with the specified type and rating only.
(
12) 27864 Issue 1 January 2008
To Next Page
Loading...
Need help?
General
