MAINTENANCE & FAULT FINDING
FAULT FINDING
rinter unit.
or Test” menu can be reached from the “Main” menu by:
or Test.
s between “On”
Reflective sensors can be activated by a blank piece of metal.
Fork sensors can be activated by inserting a thin piece of paper between the transmitter
and receiver.
Sensor test
Sometimes it is required to test the sensors of the p
To do so, go to the “Sensor Test” menu of the controller.
The “Sens
(1) Settings
(2) Hardware
(3) Diagnostics
(4) Sens
Activate the appropriate sensor and observe that the display switche
and “Off”.
Use the images on the next few pages to locate the sensors. Sensors may vary
dependent on the actual printer model.
(
210) 27864 Issue 1 January 2008
To Next Page
Loading...