MAINTENANCE & FAULT FINDING
4 Issue 1January 2008 (165)
ON LOADING RIBB
In this example a V400 is used.
Printer mounted
The carrier is shown in the start position.
(1) Press on “PARK” button on the
Controller (V400 only); this will always
bring the carrier to the opposite position
which makes it easy to change the ribbon
material.
(2) Remove the cover/cassette from the
printer (use both hands if required)
Printer open
(3) Remove the used r ibbon
material on the rewind roll.
(4) Remove the empty core from
the unwind roll and place it on
the rewind roll.
(5) Clean the print head with the
recommended Domino
VPR0222 cleaning kit.
2786
To Next Page
Loading...