INSTALLATION
System Variables
42) 27864 Issue 1 January 2008
Use this setting to assign a name to the printer. It is this name that the machine id
able (page 133) refers to.
ith the host name (see page 55).
mpted
hen the design is unloaded again,
e internal system drive is searched for information about
any design being printed. If such information is found, the design in question is loaded
and any prompted variables will automatically be filled in.
Please note that any counters and real time variables in the design is initialised as it
would be during a normal job load.
(1) Machine ID
(identity) vari
Please do not confuse the machine id w
(2) Hotstart
The system has limited hot start functionality.
When ever a design is loaded, the name of the design and all entries for pro
variables are stored on the internal system drive. W
the information is purged from the internal system drive.
If the system is switched on, th
1
2
(
To Next Page
Loading...
Need help?
General
