INSTALLATION
Note: if the printer is interrupted by a signal during printing, retraction or calculating
label, pause, not ready, it will ignore the signal. The system will first accept the
it has finished calculating. Thus producti
the next
next signal when
on will not halt if the printer’s maximum speed is
exceeded (but some products may miss a print).
ed too low
If the web speed is below 50 mm/s, a warning or error signal will be displayed on the
if the speed is too low. If
he printer remains in its current print position and when the
emains of the current print is finished.
ing or error
al will be displayed on the screen. If the Y-offset is too short the print head cannot
t pixels and hence the print may not comply with the desired quality
e minimum Y-offset depends on the print speed and the actual design to
Notice that the button is now reversed. When the default button is reversed, press the
setting you wish to reset.
If the default button was accidentally pressed, press it again to deselect it.
(3) Spe
(CM-Types)
screen, in accordance to the settings.
(4) Abort print when speed too low
(CM-Types)
By selecting the field, the printer will abort the current print
the setting is unselected t
web is started again, the r
(5) Y-offset too short
If the distance between the label start and the first line are too short, a warn
sign
print the firs
standards. Th
print.
(6) Default
The default button allows the user to reset a single setting to the factory default. To
do this press the “default” button once.
27864 Issue 1January 2008 (41)
To Next Page
Loading...
Need help?
General
