INSTALLATION
This item is described below. If ”Ribbon Warning” has been set to ”Warn
warning will be displayed on screen when the ribbon has reached the d
ing”, a
iameter set in:
s below:" (see next paragraph):
r of ribbon roll. The menu is used
activated. The most suitable diameter is based on the printer’s speed and the size of the
eset a single setting to the factory default.
When the default button is reversed, press the setting you wish to reset.
If you have accidentally pressed the default button, press it again to deselect it.
l between. By
ey the user will come to the next screen display. By
display.
(2) Print pulse when not ready
If the packing or labeling machine sends a signal whilst the printer is calculating, an
error/warning as follows can be set:
Error: If the printer is interrupted by a signal during printing, retraction, or calculating
the next label, pause or not ready, it will stop.
"Activate ribbon warning when diameter i
Activate ribbon warning when diameter is below
This menu is used to set the minimum diamete
together with “Ribbon Warning” (described above).
When ribbon diameter reaches the set value, the “Ribbon Warning” function is
print.
(4) Default
The default button allows you to r
To do this, press the “default” button once.
Notice that the button is now reversed
1
(1) The arrow keys
The “Error/Warning” menu contains two screens that the user can scrol
pressing the right-hand arrow k
pressing the left-hand arrow the user will be returned to the previous screen
2
3
6
5
4
(
40) 27864 Issue 1 January 2008