INSTALLATION
4 Issue 1January 2008 (35)
ARE
ne the settings you wish to save in the design. The menu
files.
pulse offset,
start pulse offset. Instead of changing
he optimal
values for these settings can be stored with the design.
Use the menu below to define which setting you wish to be stored in the design files.
e saved
g (in the example above:
"CONTRAST”) will select that item. By pressing the "Toggle” button (in the bottom
right-hand corner), and then "Save”, the selected setting will be saved with each
individual design.
If "CONTRAST” is subsequently altered in a design and the design is then loaded, the
CONTRAST value will update the global CONTRAST value.
SETTING UP THE FIRMW
Saved in Design
Find "Save in design" in the "Settings / Run" menu.
This menu allows you to defi
is examined in detail below:
It can sometimes be useful to store some of the settings directly in the design
A scenario could be that design1 uses a low contrast setting but a high start
while design2 requires a high contrast but a low
both contrast and start pulse offset every time the specific design is loaded, t
1
(1) Settings
This shows the user a complete list of all the settings in the printer that can b
with the individual design. Pressing on the desired settin
2786
To Next Page
Loading...
Need help?
General
