MAINTENANCE & FAULT FINDING
ELECTRICAL
Problem Action
No light showing in display on power up
The power switch must be in t
position. T
he ON
his switch is located at the rear
ck that the mains cable is correctly
nector below
on the fuse
ay and replace if necessary.
230VAC and
ns supply to the V
ER. There may
r supply.
of the Controller.
Che
inserted into the mains con
the switch.
Check that the mains fuse
selector is ok
The fuse is 3.15AT for
6,30AT for 115VAC
Check the mai
SERIES CONTROLL
be another fuse installed to protect the
Mains Cable at source.
8 A fuse defect on powe
The Controller is functioning but there is
no print reaction
Incorrect printer selection. Go to settings
in the menu, click hardware, click
printer type and chose the correct
printer.
(
234) 27864 Issue 1 January 2008
To Next Page
Loading...
Need help?
General
