INSTALLATION
In ts allation
(1
If mounting is a V200 ensure the print head is mounted on the top point of the
ket to the correct distance between the
On the V100 printer the distance should be between 1 and 1.5mm
• On the V200 the distance should be between 0.2 to 1.0mm.
V100
) Mount the printer in the bracket system.
Note:
rubber roller.
(2) Adjust the nuts on the 4 shafts of the brac
rubber plate / rubber roller and the print head.
•
1.0 - 1.2 mm
V200
0 - 1 mm
0.2 - 1 mm
27864 Issue 1January 2008 (31)
To Next Page
Loading...
Need help?
General
