INSTALLATION
4 Issue 1January 2008 (39)
warning or error
e case of
g” the user will be informed on the screen but the printer will carry on
f “Error” the printer will display an error message on screen and stop
To switch from “Error” to “Warning” simply press the button.
he arrow keys
The “Error/Warning” menu contains two screens that the user can scroll between. By
d arrow key the user will come to the next screen display. By
s screen
lay.
o independent ways of detecting the
fault.
ivates the ribbon alarm sensor
otated (measured by the ribbon warning sensor) even
g
When the ribbon roll is almost empty the ribbon-warning feature is activated (the
ribbon warning output is activated).
By setting this feature to “Error” the printer will stop when the diameter of the
ribbon roll is equal to the value set in the "Activate ribbon warning when
diameter is below:" field.
Error / Warning
This menu allows users to determine when the printer should send a
message. The difference between “Warning” and “Error” is that in th
“Warnin
operating.
In the case o
operating.
1
(1) T
pressing the right-han
pressing the left-hand arrow key, the user will be returned to the previou
disp
(2) Ribbon Alarm
When the ribbon is broken, the system has tw
• A dancer arm act
• The ribbon roll has not r
though a certain amount of ribbon was used.
(3) Ribbon Warnin
2
3
4
2786
To Next Page
Loading...
Need help?
General
