OPERATION
SETTINGS
27864 Issue 1 January 2008
e printer.
.
ardware" and
"Admin". Each menu (tab) will be examined point by point in this section.
g process.
Moreover, all these functions can be altered while the printer is working. The
“Run Settings” menu point by point.
ollowing
al.
The selections of settings should be stored in the design. If a setting is stored in a
can be defined whilst editing the design.
When gs are updated.
If a set T
This is extensive menu is used to define the general settings for th
The main “Settings” menu is illustrated below as seen by an administrator
There are four tabs at the top of the display: "Run", "System", "H
1
2
3
(1) Run Settings
Can be used to alter all those parameters that directly affect the printin
following section will examine the
The Run Settings menu allows the user to alter parameters under the f
menus: Quality, Economy, Position and Technic
(2) Settings saved in design
design, these settings
a design with settings is loaded to the printer, the global settin
ting is NO stored in the design the global values is used.
(3) P
a
variable in the start printing mode asking “Enter number of
prints”.
When the printer has printed the wanted number of labels the printing will
be stopped, and has to be restarted or stopped, depending on your choice.
Press the field “ Action when done“ to choose between Ask, Restart and
Quit Printing.
rint Counter
Marking the fields ” Enable printing of print counter” will set up
prompted
(
150)
To Next Page
Loading...
Need help?
General
