MAINTENANCE & FAULT FINDING
(1) Set All Settings Default
(which may sometimes be a
better solution). Please see page 153.
r has been physically modified.
to use the stepper motor PK265.
Use this button if the firmware has been updated AND the printer is equipped with
the stepper motor PK265.
Resets ALL run settings to factory defaults.
You have the alternative to reset just a single run setting
(2) Load Settings for Large Motor
Enables the controller to use the stepper motor PK266.
This button is only required if the printe
(3) Load Settings for Small Motor
Enables the controller
27864 Issue 1January 2008 (209)
To Next Page
Loading...
Need help?
General
