OPERATION
08
t head prints. It is recommended to set this
dependent on the type of material
being printed upon, and the type of ribbon used.
y ribbon is used, it may be necessary to increase the contrast, also note
int head can be considerably reduced.
100 and V400)
h the label design.
hip and used
The preheat function make it possible to add or remove a part of the power
calculation (temperature), which is necessary to use for printing the next dot.
This is can be used to make a final print quality adjustment, in accordance with the
needs (speed, web surface condition etc.).
Quality settings for V400 -Type
2
1
(1) Contrast
(CM, V100 and V400)
Controls the temperature at which the prin
between 80%-100%. The higher the value, the hotter the temperature used by the
print head to print. The contrast required is largely
If a low qualit
that the life of the pr
(2) Preheat
(CM, V
The preheat settings can be used to increase / decrease the heat to the print head as
additional adjustment range to the Contrast setting.
Theory:
During printing the single dots will be heated up in accordance wit
Every time a dot has been fired, this will be stored in a history memory c
for the calculation of the next print.
5
4
6
(
152) 27864 Issue 1 January 20
To Next Page
Loading...
Need help?
General
