MAINTENANCE & FAULT FINDING
(1) Set All Settings Default
set just a single run setting (which may sometimes be a better
solution). Please see page 153.
66.
odified the printer.
se the stepper motor PK265.
This button must be used if the firmware has been updated and the printer is equipped
with the stepper motor PK265.
Resets ALL run settings to factory defaults.
This is an alternative to re
(2) Load Settings for Large Motor
Enables the controller to use the stepper motor PK2
Use this button if you have physically m
(3) Load Settings for Small Motor
Enables the controller to u
27864 Issue 1January 2008 (191)
To Next Page
Loading...