MAINTENANCE & FAULT FINDING
Error No.
Error text Action
1229: nable to print. System lo
failed
ompliant
start if the
space.
U g On a CFR21 Part 11 c
system printing cannot
system log fails. Check free
1230: Invalid anchor point int setting could not be The anchor po
set. Check transmission.
1231: Error receiving design item Error encountered while receiving a
label. Check transmission.
1232: abel de the label Item Did Not Fit L The item could not be insi
border. Check the field.
1241: Text Did Not Fit Block text typed in could not be inside
. Check the
The
the rectangle specified
design item.
1242: Word Did Not Fit Max Width
A word was longer than the line
and the length. Check the field size
text.
1243: Label around the
it the label. Check the
a.
Block Did Not Fit The enveloping rectangle
field cannot f
size of the field and the dat
1244: t Did Not Fit Label is typed in to fit the Tex Too much text
label. Check the field.
1245: Xpos Greater Than Label The x position is set outside the label
Width border. Check the field.
1246: Ypos Greater Than Label is set outside the label The y position
Height border. Check the field.
1261: Access to network denied r name / password of the
the
r.
. Check use
network shortcut. Consult
network administrato
1262: Already connected to network.
The network thinks co
already been ma
nnection has
de.
1263: Shortcut name is invalid. The name of the network short cut is
invalid. Please check the name.
1264/126 rk path not network path.
me”
5: Netwo Problem with the
acceptable/invalid, or cannot
be located.
A network path syntax is:
“\\ServerName\ShareNa
1266: later. ter. Network busy. Try Try again la
1267: work connection was
cancelled.
Cancel was pressed before the
connection was established.
Net
1268: Device is already remembered.
The network thinks you are already
connected.
1269: The specified password is
invalid.
Check the password.
27864 Issue 1January 2008 (229)
To Next Page
Loading...