MAINTENANCE & FAULT FINDING
Error No.
Error text Action
1403: Unknown Send Id is not
nized by the protocol. Check
The information to send
recog
transmission.
1404: ETB Missing ntrol character is missing. Check A co
transmission.
1405: Unable to start receive thread Could not initialize networking
features. Reboot unit.
1406: Init Serial port Could not open serial port. Try to
g baud reopen the port by switchin
rate.
1407: Read Timeout as read, but
od of time.
e.
The start of a command w
the remainder of the command was
not received within a peri
Check the sending devic
1408: Memory Allocation Failed Could not allocate enough memory.
1409: Write Timeout t data. The receiver does not accep
Check cable.
1410: Invalid Handle The internal handle used for the
r another
cking the port.
transmission is invalid. Either the port
was not opened properly o
device is blo
1411: Error Creating send block t in blocks.
One such block could not be created.
Any transmission is sen
Check transmission.
1412: Error Reading String A string was supposedly sent but the
ize the
r the baud
andshake.
receiver could not recogn
format.
Check transmission. Lowe
rate. Enable Hardware h
1413: teger posedly sent but
nize the
r the baud
andshake.
Error Reading In An integer was sup
the receiver could not recog
format.
Check transmission. Lowe
rate. Enable Hardware h
1414: Error Reading Double A floating point number was
supposedly sent but the receiver could
not recognize the format.
Check transmission. Lower the baud
rate. Enable Hardware handshake.
27864 Issue 1January 2008 (231)
To Next Page
Loading...
Need help?
General
