INSTALLATION
Print head temperature
Use this menu to set a warm up temperature for the print head (requires a heating
ess than 10 degrees Celsius)
If no heater is installed (or you do not wish to use it) set the requested temperature to
(V400 printers)
Moves the print head carrier to/from park position.
element in the print head).
The current temperature can be monitored here as well.
For applications where the ambient temperature is cold (l
the print quality can sometimes improve if the heater is activated.
zero.
(6) Park
(
58) 27864 Issue 1 January 2008
To Next Page
Loading...