20140704#1.0 EBS Ink Jet Systeme
103
If the Invert check box is ticked, then where the Rectangle ”covers” another
object in a lower layer, the common section of the rectangle and another object
is not printed.
With the Line thickness parameter you can set the thickness of the rectangle
outline. The parameter is disabled when the Filled check box is ticked.
Touch the button in order to confirm the settings.
Shape-type Object – Ellipse
The Ellipse object allows you to print any ellipse: an outline only or the entire
figure (in the latter case the Filled check box needs to be ticked).
If the Invert check box is ticked, then where the Ellipse ”covers” another object
in a lower layer, the common section of the ellipse and that another object is not
printed.
With the Line thickness parameter you can set the thickness of the ellipse
outline. The parameter is disabled when the Filled check box is ticked.
Touch the button in order to confirm the settings.
Line Divider
If a division mark is added to a project, you can make printouts of several text
files quickly on successive lines or on various spots on an article.
Touch the button and then touch the button in order to add a new,
Line divider-type text object to a project.
To Next Page
Loading...
