EBS HANDJET EBS-260 - Conformity Marking; Environmental Protection

20140704#1.0 EBS Ink Jet Systeme
EN
 11
EN
Conformity Marking
The HANDJET
®
EBS-260 printer has followed the conformity assessment
procedure which resulted in the issue of Declaration of Conformity. This forms
the basis for the statement that the HANDJET
®
EBS-260 printer and the
manufacturer’s accessories, to which this Declaration relates, meet the general
requirements and other relevant provisions of the Directive if the printer and the
accessories are installed and used in compliance with the manufacturer's
instructions:
1999/5/EC, 2006/95/EC, 2004/108/EC
and that they meet the following norms that are harmonized with the above
Directives
EN 60950-1:2006 + A11:2009 + A1:2010,
EN 60825-1:2007 + AC1:2008,
ETSI EN 301 489-1 V1.9.2:2011,
ETSI EN 301 489-17 V2.2.1:2012,
EN 55022:2011,
EN 61000-3-2:2006 + A1:2009 + A2:2009,
EN 61000-3-3:2013,
EN 61000-4-2:2009,
EN 61000-4-3:2006 + A1:2008 + IS1:2009 + A2:2010,
EN 300 328 V1.8.1:2012.
The HANDJET
®
EBS–260 printer will bear the following mark:
Environmental Protection
After the printer has been put out of service, do not take it out together
with other domestic waste.
According to Directive No 2012/19/EU of the European Council on
electrical and electronic equipment waste, the HANDJET
®
EBS-260
printer and USB-Bluet
ooth modules that have been put out of service must be separated from
domestic waste and processed in an environmentally friendly way.