EBS HANDJET EBS-260 - Uestions and Problems; Technical Parameters.124

 124
EN
EBS Ink Jet Systeme 20140704#1.0
EN
Reduce the setting of the Dot size parameter by touching the „-„ button (R) on
main screen of the printer or change it by modifying printing parameters – see
Printing Parameters (p. 65).
Questions and Problems
Should you have additional queries after reading this operating manual, you can:
 Browse the EBS Ink Jet Systeme, the printer manufacturer's web site
 Try asking a question to the manufacturer’s representative,
 Present the problem in the contact form available on the manufacturer’s
web site and forward the form following the instructions given therein.
 Technical Parameters
Parameter
Description
Number of nozzles
32
Nozzle diameter
150µm as standard
optionally: 120µm, 170µm, 200µm
Print height
56 mm
Height of objects to be labeled
from 115 mm (contact with both
rolls),
from 39 mm (contact with the lower roll to
print with for example 7 nozzles only -
see figure
D
).
Working position in 3D space
any
Number of text lines per run
Up to 4 lines
Maximum number of characters
per text
Constrained by internal memory of the
printer
Number of projects (stored in the
printer’s memory at the same time)
Constrained by internal memory of the
printer
Printing of graphics (logo,
special graphic characters)
Texts and graphic symbols can be edited
and printed with the application of True
Type fonts and also by means of UTF–8
characters, as standard
Special characters
Diacritical characters, graphic characters
for information, warning, transport, etc.
purposes