EBS HANDJET EBS-260 - Page 13

20140704#1.0 EBS Ink Jet Systeme
EN
 13
EN
project window
J
Preview a project to be printed
K
Select projects to be printed, from the same folder
L
Open a project to be printed
M
Edit a project to be printed and printing parameters of that project
N
Save the
project
parameters
modified
If a modification is not saved, the project can be
printed with the modified parameter only until a new
project is opened or the printer is switched off.
O
Project number in the folder / the number of projects in the folder
P
Project name (if the name is in green, the project is ready for printing)
print intensity
R
Decrease or
increase print
intensity
A change in the intensity setting results in a lower or
higher saturation of a printout with ink of a given
color.
You can change the intensity of a printout of a
chosen project by pressing the - or + button or by
shifting the slider handle. If the parameter setting is
modified, press the N button to save the
modifications to the project.
print resolution
S
Increase or
decrease print
resolution
A change in the width of characters printed and the
length of the entire project are the visual effects of a
modification to the resolution setting.
You can change the resolution of a chosen project
by pressing the – or + button or by shifting the slider
handle. If the parameter setting is modified, press
the N button to save the modifications to the project.
menu bar
T
Create a new project and edit an existing project – see Creating a
New Project (p. 41) and Opening and Editing a Project (p. 41)
U
Set the language, date and time format (General Settings (p. 21)),
sound (Sound Settings (p. 23)), energy (Energy Management (p.
25)), users (User Manager (p. 28)), WiFi (WiFi Wireless Connection
(p. 29)) and Bluetooth (Bluetooth Interface (p. 32)), service options –
see Service (p. 69)
W
Enable and disable printing – see Printing a Project via Printer LCD
(p. 118), rinse the nozzles – see also Purging (p. 70) and Measure
(p. 118)
Make sure that the edges of the housing are not touched while LCD buttons are
being touched on the screen touch – this may disrupt the detection of a touch.
If the touch screen cannot be used (e.g. the operator wears gloves), the keys
available on the keypad 10 can be used instead. With the key 24 you can switch
over between the project window and printing parameter windows. The active
window is framed in black. The keys 25 and 26 are designed for choosing a
project and changing the parameter settings.