Ecolab Elados EMP II E60 - Display in the Operating Display; Setting; Operation Mode; Pulse

417101438_EMPII_E60.docx
- 101 -
Rev. 11-02.14
10.2.2.2 Display in the operating display/ Setting
The metering rate can be configured / adjusted in the operating display during operations.
NOTE
If the newly set value is not confirmed within 10 seconds by pressing the START/STOP
key, the system reverts to the primarily value.
Strokes/min
Percent (%)
Fig. 10.4 Display inthe operating display / Setting: Strokes
Fig. 10.5 Display inthe operating display / Setting: Percent
Liter
Gallons
Fig. 10.6 Display inthe operating display / Setting: Liter
Fig. 10.7 Display inthe operating display / Setting: Gallons
10.2.3 Operation mode / pulse
For the “pulse” operation mode, the metering pump only works in conjunction with incoming
pulses (e.g. from a contact water meter).
The following pulse processing options can be selected:
• Multiplication Incoming pulses are multiplied by a configurable factor (n):
1 pulse = n pump strokes (default setting)
• Division Incoming pulses are divided by a configurable factor (n):
n pulse = 1 pump stroke