Ecolab Elados EMP II E60 - Overview; Operating Data; Operating Hours; Selecting; Displaying; Deleting; Operating Data; Litre

417101438_EMPII_E60.docx
- 122 -
Rev. 11-02.14
10.5.1 Overview
Fig. 10.62 Operating data: Overview
see chapter 10.5.2
see chapter
10.5.3
see chapter
10.5.4
10.5.2 Operating data / Operating hours
The pump running time (number of strokes x 480 ms) is displayed since it was first
commissioned or last reset.
10.5.2.1 Selecting / Displaying / Deleting
Fig. 10.63 Operating data / Operating hours: Selecting / Displaying / Deleting
10.5.3 Operating data / Litre
The metered quantity in litres since the pump was first commissioned or last reset is
displayed. On operating the pump without an oval gear meter, this value is calculated
(ml/stroke x number of metered strokes). If an oval gear meter is connected, the measured
quantity is displayed (determined from the number of oval gear meter pulses).
10.5.3.1 Selecting / Displaying / Deleting
Fig. 10.64 Operating data / litre: Selecting / Displaying / Deleting