Patient Monitor User Manual Care and Cleaning
- 222 -
30.2.1 Cleaning the Monitor
WARNING
Before cleaning the monitor, make sure that the monitor is switched off and disconnected
from the power line.
To surface-clean the monitor, follow these steps:
1. Switch off the monitor and disconnect it from the power line.
2.
Wipe the entire exterior surface, including the screen, of the equipment using a soft cloth
dampened with the cleaning solution thoroughly until no visible contaminants remain.
3.
After cleaning, wipe off the cleaning solution with a fresh cloth or towel dampened with tap
water until no visible cleaning agent remains.
4.
Dry the monitor in a ventilated and cool place.
30.2.2 Cleaning the Reusable Accessories
29.2.2.1 Cleaning the ECG Cable Assembly
1. Wipe the cable assembly with a soft cloth dampened with the cleaning solution until no
visible contaminants remain.
2.
Wipe off the cleaning solution with a fresh cloth or towel, dampened with tap water after
cleaning until no visible cleaning agent remains.
3.
Wipe off residual moisture with a dry cloth.
4.
Leave the cable assembly to air dry.
30.2.2.2 Cleaning the Blood Pressure Cuff
Cleaning the Cuff:
1. Take out the air bladder before cleaning.
2.
Hand wash the cuff with the cleaning solution; clean the air bladder with a soft cloth
dampened with the cleaning solution. until no visible contaminants remain
3.
Rinse the cuff and wipe off the cleaning solution with a fresh cloth or towel dampened with
tap water after cleaning until no visible cleaning agent remains.
4.
Wipe off residual moisture with a dry cloth.
5.
Air dry the cuff thoroughly after cleaning.
Replacing the Air Bladder:
After cleaning, replace the air bladder into the cuff following the steps below:
1.
Roll the bladder lengthwise and insert it into the cuff from the large opening at one end of
the cuff.
To Next Page
Loading...
Need help?
General
