Patient Monitor User Manual Basic Operation
- 37 -
3. The connected iM20 enters into privacy mode simultaneously.
4. Audio alarm paused status discontinues. Audio alarm off, alarm off, alarm reset and alarm
latch status are not influenced.
The monitor exits privacy mode in any of the conditions:
1. The user clicks anywhere on the screen or presses any key (except Power ON/OFF key).
2. Battery Low alarm occurs.
3. The monitor is disconnected with MFM-CMS.
4. When iM20 or any module is mounted to the monitor.
NOTE:
1 When the monitor is in transfer status, do not use privacy mode, otherwise,
device/data transferring might be affected.
2 The monitor is unable to enter into privacy mode when exporting data.
3.4.5 NFC Mode
NFC mode means HR physiological alarms can't be turned off. To configure NFC mode, select
Menu > Maintenance > User Maintain > Alarm Setup and choose NFC Mode which can be
set to On or Off. NFC mode is off by default.
In NFC mode:
1. The HR physiological alarms are always on and can't be set to off by the user.
2. The user can't turn off the audio alarm permanently.
3. The audio alarm off status will be finished and the monitor enters normal alarm response
status. Pause Time will automatically switch to 120 s, which can be set to 60 s, 120 s, or 180
s manually.
4. The audio alarm paused status is not affected by entering NFC mode.
5. Prompt information NFC Mode On is displayed.
6. Monitoring data, alarm information, stored data and monitor status are transmitted to
MFM-CMS.
NOTE:
NFC mode and standby mode can't coexist. When the monitor enters the standby mode,
the NFC mode will automatically pause. After exiting the standby mode, the monitor will
automatically resume the NFC mode.
After exiting NFC mode:
1. The HR physiological alarms are still on and can be set to off by the user.
2. Pause Time keeps no change and the user can set it to Permanent.
3. Prompt information NFC Mode On gets disappeared.
To Next Page
Loading...
Need help?
General
