Patient Monitor User Manual Basic Operation
- 40 -
3.11 Disabling the Touch Screen
The user can disable touch screen operation by selecting and holding the permanent key
for three seconds. A message of Screen Locked and the symbol will be displayed at the
bottom of screen. To enable the touch screen operation, select the symbol by using the knob.
3.12 Using the Bar Code Scanner
To enter the barcode setup menu, select Menu > Maintenance > User Maintain, after entering
the required password ABC, select Other Setups > BarCode Setup. You can configure the
settings such as MRN, Last Name, and First Name and so on.
User can also check relevant scanner device information in User Maintain > Scanner
Management.
If the scanner is connected for the first time, the monitor will pop up a confirmation message to
ask user whether the new USB device is added as scanner. Choose Yes to add as scanner, choose
No to add as USB device. Please refer to chapter Accessories for the recommended scanner.
NOTE:
The start and end code should be set before using scanner to update patient, otherwise
the barcode can’t be recognized normally. After setting start and end code, user should
also set male code and female code to distinguish the gender.
To Next Page
Loading...
Need help?
General
