Edge-Core EAP8518 - Page 128

C HAPTER 13 | System Management Commands
– 128 –
apmgmtui snmp This command enables and disables SNMP management access to the AP.
SYNTAX
apmgmtui snmp [enable | disable]
enable - Enables SNMP management access.
disable - Disables SNMP management access.
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
EXAMPLE
AP(config)# apmgmtui snmp enable
AP(config)#
apmgmtip This command specifies the client IP addresses that are allowed
management access to the access point through various protocols.
N OTE : Secure Web (HTTPS) connections are not affected by the UI
Management or IP Management settings.
SYNTAX
apmgmtip [multiple <ip-address> <subnet-mask> | single <ip-
address> | any]
multiple - Adds IP addresses within a specifiable range to the
SNMP, web and Telnet groups.
single - Adds an IP address to the SNMP, web and Telnet groups.
any - Allows any IP address access through SNMP, web and Telnet
groups.
ip-address - Adds IP addresses to the SNMP, web and Telnet groups.
subnet-mask - Specifies a range of IP addresses allowed
management access.
DEFAULT SETTING
All addresses
COMMAND MODE
Global Configuration