C
HAPTER
13
| System Management Commands
– 129 –
COMMAND USAGE
â—† If anyone tries to access a management interface on the access point
from an invalid address, the unit will reject the connection, enter an
event message in the system log, and send a trap message to the trap
manager.
â—† Management access applies to SNMP, HTTP (web), Telnet, and SSH
connections.
EXAMPLE
This example restricts management access to the specified addresses.
AP(config)#apmgmtip multiple 192.168.1.50 255.255.255.0
AP(config)#
show
apmanagement
This command shows the AP management configuration, including the IP
addresses of management stations allowed to access the AP, and the
protocols that are open to management access.
COMMAND MODE
Exec
EXAMPLE
AP#show apmanagement
Management AP Information
=================================
AP Management IP Mode: Any IP
Telnet UI: Enable
WEB UI : Enable
SNMP UI : Enable
==================================
AP#
show system This command displays basic system configuration settings.
DEFAULT SETTING
None
COMMAND MODE
Exec
EXAMPLE
AP#show system
System Information
==========================================================
Serial Number : A123456789
System Up time : 0 days, 4 hours, 33 minutes, 29 seconds
System Name : 11n_AP
System Location :
To Next Page
Loading...
Need help?
General
