C
HAPTER
21
| MAC Address Authentication Commands
– 172 –
RELATED COMMANDS
address filter entry
address filter entry This command enters a MAC address in the filter table.
SYNTAX
address filter entry <allowed | denied> <mac-address>
allowed - Entry is allowed access.
denied - Entry is denied access.
mac-address - Physical address of client. (Enter six pairs of
hexadecimal digits separated by hyphens; e.g., 00-90-D1-12-AB-
89.)
DEFAULT
None
COMMAND MODE
Global Configuration
COMMAND MODE
â—† The access point supports up to 1024 MAC addresses.
â—† An entry in the address table may be allowed or denied access
depending on the global setting configured for the address entry
default command.
EXAMPLE
AP(config)#address filter entry allowed 00-70-50-cc-99-1a
AP(config)#
RELATED COMMANDS
address filter default
address filter delete This command deletes a MAC address from the filter table.
SYNTAX
address filter delete <allowed | denied> <mac-address>
allowed - Entry is allowed access.
denied - Entry is denied access.
mac-address - Physical address of client. (Enter six pairs of
hexadecimal digits separated by hyphens; e.g., 00-90-D1-12-AB-
89.)
To Next Page
Loading...
Need help?
General
