C
HAPTER
26
| Wireless Interface Commands
ā 207 ā
EXAMPLE
AP(if-wireless 0)# rts-threshold 0
This setting has not been effective !
If want to take effect, please execute make-RF-setting-effective command !
AP(if-wireless 0)#
ssid This command configures the service set identifier (SSID) of the VAP.
SYNTAX
ssid <string>
string - The name of a basic service set supported by the access
point. (Range: 1 - 32 characters)
DEFAULT SETTING
vap_a0 to vap_a7 (for VAPs 0-7)
COMMAND MODE
Interface Configuration (Wireless-VAP)
COMMAND USAGE
Clients that want to connect to the wireless network through an access
point must set their SSIDs to the same as that of the access point.
EXAMPLE
AP(if-wireless 0: VAP[0])# ssid net-name
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
closed-system This command prohibits access to clients without a pre-configured SSID.
Use the no form to disable this feature.
SYNTAX
[no] closed-system
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration (Wireless-VAP)
To Next Page
Loading...
