Figure 230: RPS Cable and AC Power Cord Connections for the STK-RPS-1005PS
1 = STK-RPS-1005PS power supply
7 = AC power outlet with ground connection for switch
2 = Switch 8 = Redundant power supply connector on power supply
3 = RPS cable 9 = Redundant power supply connector on switch
4 = RPS AC power cord 10 = AC connector on power supply
5 = Switch AC power cord 11 = AC connector on switch
6 = AC power outlet with ground connection for power
supply
1. Connect one end of the RPS cable (3) to the RPS connector at the rear of the power supply (8).
2. Connect the other end of the RPS cable (3) to the RPS connector on the switch (9).
Note
AC power cords and outlets vary depending on country. See Selecting Power Supply
Cords on page 483 for more information.
Installing External Power Supplies
Connecting the RPS Cable and AC Power Cord to an
STK-RPS-1005PS
ExtremeSwitching Hardware Installation Guide 289
To Next Page
Loading...
Need help?
General
