Removing Switches from Service
Removing an AC Power Supply on page 374
Removing a DC Power Supply on page 375
Removing a Switch from a Rack on page 376
Removing a switch from service is a two-step process:
1. Disconnect the switch from its power source, following these steps as applicable:
• Disconnect and remove the switch's removable AC power supply. See Removing an AC Power
Supply on page 374.
• Disconnect and remove the switch's removable DC power supply. See Removing a DC Power
Supply on page 375.
• Disconnect the switch from its redundant power supply.
2. Remove the switch from the rack, following the steps in Removing a Switch from a Rack on page
376.
Note
Read the information in this chapter thoroughly before you attempt to remove a switch.
Removing an AC Power Supply
To remove an AC power supply unit (PSU) from a switch, follow these steps:
1. Disconnect the AC power cord from the wall outlet and from the power input connector on the
power supply.
374
ExtremeSwitching Hardware Installation Guide
To Next Page
Loading...
Need help?
General
