Extreme Networks ExtremeWare XOS Guide - Page 128

Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.3 Concepts Guide
128
Lag Actor Actor Partner Partner Partner Agg
Sys-Pri Key MAC Sys-Pri Key Count
--------------------------------------------------------------------------------
4:5 100 0x0fa5 00:01:30:f9:9c:30 321 0x1f47 16
Port list:
Member Rx Sel Mux Actor Partner
Port State Logic State Flags Port
--------------------------------------------------------------------------------
4:5 Current Selected Collect-Dist A-GSCD-- 8015
4:6 Current Selected Collect-Dist A-GSCD-- 8016
4:7 Current Selected Collect-Dist A-GSCD-- 8017
4:8 Current Selected Collect-Dist A-GSCD-- 8019
4:25 Current Selected Collect-Dist A-GSCD-- 8020
================================================================================
Actor Flags: A-Activity, T-Timeout, G-Aggregation, S-Synchronization
C-Collecting, D-Distributing, F-Defaulted, E-Expired
The following is an example of the output you see when you add the detail parameter for LAG 1 on a
modular switch:
show lacp lag 1 detail
Lag Actor Actor Partner Partner Partner Agg
Sys-Pri Key MAC Sys-Pri Key Count
--------------------------------------------------------------------------------
4:5 100 0x0fa5 00:01:30:f9:9c:30 321 0x1f47 16
Up : Yes
Enabled : Yes
Unack count : 0
Wait-for-count : 0
Receive state : Enabled
Transmit state : Enabled
Selected count : 16
Standby count : 0
LAG Id flag : Yes
S.pri:100 , S.id:00:04:96:10:33:60, K:0x0fa5
T.pri:321 , T.id:00:01:30:f9:9c:30, L:0x1f47
Port list:
Member Rx Sel Mux Actor Partner
Port State Logic State Flags Port
--------------------------------------------------------------------------------
4:5 Current Selected Collect-Dist A-GSCD-- 8015
4:6 Current Selected Collect-Dist A-GSCD-- 8016
4:7 Current Selected Collect-Dist A-GSCD-- 8017
4:8 Current Selected Collect-Dist A-GSCD-- 8019
4:25 Current Selected Collect-Dist A-GSCD-- 8020
================================================================================
Actor Flags: A-Activity, T-Timeout, G-Aggregation, S-Synchronization
C-Collecting, D-Distributing, F-Defaulted, E-Expired
To display LACP information for a specific port that is a member of a LAG, issue the following
command:
show lacp member-port <port> {detail}