Extreme Networks ExtremeWare XOS Guide User Manual

Displaying Port Configuration Information
ExtremeWare XOS 11.3 Concepts Guide
145
Port Display—BlackDiamond 10K Series Switch Only
The switch displays slightly different information for various ports, depending on the speed and media.
The following command displays more specific information for a slot 1, port 1 on a BlackDiamond 10K
switch:
show ports 1:1 information detail
Following is sample output from this command:
Port: 1:1
Virtual-router: VR-Default
Type: UTP
Random Early drop: Disabled
Admin state: Enabled with auto-speed sensing auto-duplex
Link State: Active, 100Mbps, full-duplex
Link Counter: Up 1 time(s)
VLAN cfg:
Name: peggy, Internal Tag = 4094, MAC-limit = No-limit
STP cfg:
Protocol:
Name: peggy Protocol: ANY Match all protocols.
Trunking: Load sharing is not enabled.
EDP: Enabled
DLCS: Unsupported
lbDetect: Unsupported
Learning: Enabled
Unicast Flooding: Enabled
Multicast Flooding: Enabled
Broadcast Flooding: Enabled
Jumbo: Disabled
BG QoS monitor: Unsupported
QoS Profile: None configured
Queue:
QP1 MinBw = 0% MaxBw = 100% Pri = 1
QP2 MinBw = 0% MaxBw = 100% Pri = 2
QP3 MinBw = 0% MaxBw = 100% Pri = 3
QP4 MinBw = 0% MaxBw = 100% Pri = 4
QP5 MinBw = 0% MaxBw = 100% Pri = 5
QP6 MinBw = 0% MaxBw = 100% Pri = 6
QP7 MinBw = 0% MaxBw = 100% Pri = 7
QP8 MinBw = 0% MaxBw = 100% Pri = 8
Ingress Rate Shaping : Unsupported
Ingress IPTOS Examination: Disabled
Egress IPTOS Replacement: Disabled
Egress 802.1p Replacement: Disabled
NetLogIn: Disabled
Smart redundancy: Enabled
Software redundant port: Enabled
Primary: 1:1
Redundant: 1:2
Redundant link configuration: Off
autopolarity: Enabled

Extreme Networks ExtremeWare XOS Guide Specifications

General

Brand	Extreme Networks
Model	ExtremeWare XOS Guide
Category	Software
Language	English