Configuring Slots and Ports on a Switch
ExtremeWare XOS 11.3 Concepts Guide
134
â—Ź Switch VLAN IP information
â—Ź Switch port number
â—Ź Switch configuration data: duplex and speed
EDP is enabled on all ports by default. EDP enabled ports advertise information about the Extreme
Networks switch to other switches on the interface and receives advertisements from other Extreme
Networks switches. Information about other Extreme Networks switches is discarded after a timeout
interval is reached without receiving another advertisement.
To disable EDP on one or more ports, use the following command:
disable edp ports [<ports> | all]
To enable EDP on specified ports, use the following command:
enable edp ports [<ports> | all]
To clear EDP counters on the switch, use the following command:
clear lacp counters
This command clears the following counters for EDP protocol data units (PDUs) sent and received per
EDP port:
â—Ź Switch PDUs transmitted
â—Ź VLAN PDUs transmitted
â—Ź Transmit PDUs with errors
â—Ź Switch PDUs received
â—Ź VLAN PDUs received
â—Ź Received PDUs with errors
To view EDP port information on the switch, use the following command:
show edp
The following is sample output from the show edp command (the screen display was interrupted in the
following sample) on a modular switch:
EDP advert-interval :60 seconds
EDP holddown-interval :180 seconds
EDP enabled on ports :1:1 1:2 1:3 1:4 1:5 1:6 1:7 1:8 1:9 1:10 1:11
1:12 1:13 1:14 1:15 1:16 1:17 1:18 1:19 1:20 1:2
1 1:22
1:23 1:24 2:1 2:2 2:3 2:4 2:5 2:6 2:7 2:8 2:9
2:10 2:11 2:12 2:13 2:14 2:15 2:16 2:17 2:18 2:1
9 2:20
2:21 2:22 2:23 2:24 2:25 2:26 2:27 2:28 2:29 2:3
0 2:31
2:32 2:33 2:34 2:35 2:36 2:37 2:38 2:39 2:40 2:4
1 2:42
Additionally, you view EDP information by using the following command:
show edp port <ports> detail
The following is sample output from the show edp ports 1:1 detail command on a modular
switch:
To Next Page
Loading...
Need help?
General
