Policy Manager
ExtremeWare XOS 11.3 Concepts Guide
260
Applying Routing Policies
To apply a routing policy, use the command appropriate to the client. Different protocols support
different ways to apply policies, but there are some generalities. Policies applied with commands that
use the keyword
import-policy control the routes imported to the protocol from the switch routing
table. The following are examples for the BGP and RIP protocols:
configure bgp import-policy [<policy-name> | none]
configure rip import-policy [<policy-name> | none]
Commands that use the keyword route-policy control the routes advertised or received by the
protocol. For BGP and RIP, here are some examples:
configure bgp neighbor [<remoteaddr> | all] {address-family [ipv4-unicast | ipv4-
multicast]} route-policy [in | out]
[none | <policy>]
configure bgp peer-group <peer-group
-name> route-policy [in | out] [
none | <policy>]
configure rip vlan [<vlan-name> | al
l] route-policy [in | out] [<pol
icy-name> | none]
Other examples of commands that use route policies include:
configure ospf area <area-identifier
> external-filter [<policy-map>
|none]
configure ospf area <area-identifier
> interarea-filter [<policy-map>
| none]
configure rip vlan [<vlan-name> | al
l] trusted-gateway [<policy-name
> | none]
To remove a routing policy, use the none option in the command.
To Next Page
Loading...
Need help?
General
