Power Over Ethernet
ExtremeWare XOS 11.3 Concepts Guide
176
Displaying Slot PoE Information
You can display PoE status and statistics per slot.
Displaying Slot PoE Status
Use the following command to display PoE status for each slot:
show inline-power slot <slot>
The command provides the following information:
● Inline power status—The status of inline power. The status conditions are:
■ Enabled
■ Disabled
● Firmware status—The operational status of the slot. The status conditions are:
■ Operational
■ Not operational
■ Disabled
■ Subsystem failure
■ Card not present
■ Slot disabled
● Budgeted power—The amount of power, in watts, that is available to the slot.
● Measured power—The amount of power, in watts, that is currently being used by the slot.
Following is sample output from this command:
Budgeted Measured
Slot Inline-Power Firmware Status Power (Watts) Power (Watts)
3 Enabled Operational 80 W 65 W
Displaying Slot PoE Statistics
Use the following command to display the PoE statistics for each slot:
show inline-power stats slot <slot>
The command provides the following information:
● Firmware status—Displays the firmware state:
■ Operational
■ Not operational
■ Disabled
■ Subsystem failure
■ Card not present
■ Slot disabled
● Firmware revision—Displays the revision number of the PoE firmware.
● Total ports powered—Displays the number of ports powered on specified slot.
● Total ports awaiting power—Displays the number of remaining ports in the slot that are not
powered.
To Next Page
Loading...