Extreme Networks ExtremeWare XOS Guide - Port Display-Summit X450 Switch Only

Displaying Port Configuration Information
ExtremeWare XOS 11.3 Concepts Guide
143
Port Display—Summit X450 Switch Only
The following command displays more specific information for port 3 on a Summit X450 switch:
show ports 3 information detail
Following is sample output from this command:
Port: 3
Virtual-router: VR-Default
Type: UTP
Random Early drop: Disabled
Admin state: Enabled with auto-speed sensing auto-duplex
Link State: Active, 1 Gbps, full-duplex
Link Counter: Up 1 time(s)
VLAN cfg:
Name: Default, Internal Tag = 1 (MAC-Based), MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default Protocol: ANY Match all protocols.
Trunking: Load sharing is not enabled.
EDP: Enabled
DLCS: Unsupported
lbDetect: Unsupported
Learning: Enabled
Unicast Flooding: Enabled
Multicast Flooding: Enabled
Broadcast Flooding: Enabled
Jumbo: Disabled
BG QoS monitor: Unsupported
Egress Port Rate: 128 Kbps, Max Burst Size: 200 Kb
Broadcast Rate: No-limit
Multicast Rate: No-limit
Unknown Dest Mac Rate: No-limit
QoS Profile: QP3 configured by user
Ingress Rate Shaping : Unsupported
Ingress IPTOS Examination: Disabled
Egress IPTOS Replacement: Disabled
Egress 802.1p Replacement: Disabled
NetLogin: Enabled
NetLogin authentication mode: MAC based
NetLogin port mode: MAC based VLANs
Smart redundancy: Enabled
Software redundant port: Disabled
Preferred medium: Fiber